Note: to implement this function, you need to update both the driver and SDK in allinone package. Beta Ver. SDK Update Log. However their drivers used are different, so please check the your model before download drivers.
Beta Version. The camera requires an input voltage between 11V and If the input voltage is too low the camera will stop functioning or it may reboot when the TEC power percent is high, causing a drain on the power. Therefore, please make sure the input voltage arrived to the camera is adequate.
It is advised that a very long 12V power cable not be used. It is better to place the 12V AC adapter closer to the camera. First connect the 12V power supply, then connect the camera to your computer via the USB3. Make sure the camera is plugged in before connecting the camera to the computer, otherwise the camera will not be recognized. When you connect the camera for the first time, the system discovers the new device and looks for drivers for it.
Please note that the input voltage cannot be lower than With this the device can be identified in other capture software. How to install it? Before using software, make sure you have connected the cooling camera to the 12V power supply and connected it to the computer with a USB3. It takes a significant amount of processing power and memory to capture, buffer, display and process. A x Although the camera has 4GB of internal memory, bit software will run within this memory area and the remaining memory may be not sufficient for normal operation.
For example, here we set the target temperature to C. The temperature of the CMOS sensor will drop quickly to this temperature approximately minutes. If you want to turn off cooling, you can choose Stop. If you just want to set the TEC power but not the temperature. Launch SharpCap. If the software and drivers mentioned above are installed successfully, the video image will appear automatically about 3 seconds after the software loads.
You will also see the frame rate in the lower left corner of the software window as shown below. Safety instructions and precautions 1. Safety instructions and precautions. Safety instructions 1. Precautions: 1. Before installation, you need to prepare the tools needed to install the filter wheel: tweezers, medium cross screwdriver, clock screwdriver. After the installation is complete, please use the software to control the color wheel rotation to see if the rotation is smooth and whether every position can come.
Whether there is a serious card in the middle if there is a slight card in the middle, it will not affect the use, the color wheel will continue to rotate until it reaches the target. Do not push hard when installing the filter wheel. Failure to do so may result in bearing crushage and other malfunctions or damage. There is the 12V power in the 4PIN socket.
So it does not need any extra power supply. You can use the USB socket to connect with the computer. When using this method. The current drawing from USB cable will reduce to less than mA when motor rotating. Reset button : After pressing, the filter wheel hardware is reset, the turntable returns to the initial position, the default hole 1 Filter wheel standard accessories 1. Take MDL as example. Then, connect the filter wheel and camera with 4pin wires in sequence except for the special trigger cable except QHY9 , connect the camera and computer with USB cable, and connect a 12V power supply to power the camera.
After the correct connection, the third generation filter wheel will automatically rotate two turns and then rest. First, we need to switch the control port button shown by the red arrow in the figure below to implement USB port control.
Observation indicator red light indicates USB control mode. This will ensure that the software runs in an orderly manner. As shown below:. Click on Advanced in the lower left corner. Log in. Enter into that directory. Port: Standard port property. Configuration Group: Filter Names: To adjust the name of each filter.
0コメント